Skip to Content

Physical Inventory Tolerance check for quantity

Hello All,

When I perform the physical inventory counting for WM, the tolerance check is always done on amount. Could you please suggest if there is a way to perform this tolerance check on quantity basis?

For example, if the count entered for a bin is above certain quantity, it should provide us a message.

Regards

Sandeep

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Feb 27 at 11:28 AM

    If you are using standard SAP count transaction (LI11N) then tolerance message is always on quantity and not on value.

    Logic to get the percentage value in standard SAP is

    (Quantity entered on inventory count screen - Book stock ) * 100 / Book stock

    e.g (800 - 200) * 100 / 200

    In this case the information message on bottom left corner will be

    "Difference compared to book quantity 300.00% "

    Add comment
    10|10000 characters needed characters exceeded