on 07-15-2008 8:42 AM
Hi,
Is it possible to stop the teco of a maint.order if the component assigned to order not issued.
Give ur valuable answers.
sunil
Thanks
PeteA and Ramesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
As a std no u can not stop since u in planning u planned the spares but later on u came to know it is not needed & u have not issued.
Even though if want to make it mandatory try with
following exitxs
CONF0001 Enhancements in order confirmation
CONFPM01 PM/SM order conf.: Determine cust. specific default values
CONFPM02 PM/SM order confirmation: Customer specific input checks 1
CONFPM03 PM/SM order conf.: Cust. spec. check after op. selection
CONFPM04 PM/SM order conf.: Customer specific input check 2
CONFPM05 PM/SM order conf.: Cust. specific enhancements when saving
Ramesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sunil,
Probably, by user-exit IWO10004 (Customer check for order completion).
PeteA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
110 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.