Generation of condition table CNCCRMPRCUS701 failed

[Former Member]

Hi Experts,

I created a custom adapter object ZDNL_COND_A701 for the condition key Plant/Ctrl Code/Material

All the previous steps like running DNL_CUST_CNDALL is completed.

Now when I run this custom adapter object in R3AS tcode, its in running status.

I checked in SMQ2 tcode, the status was sysfail and I was routed to SMW01. where it said that "There is no active target table for an application for usage A".

So went to the report /SAPCND/RV12N001 and executed it..it says

"Field MAINT_STAT of table is not referenced in access CRM PR 0701"

"Field INVENT_LOC of table is not referenced in access CRM PR 0701"

"Field TAX_TARIFF_CODE of table is not referenced in access CRM PR 0701"

"Field RELEASE_STAT of table is not referenced in access CRM PR 0701"

"Creating names of generated objects failed"

I went into SPRO Tcode - CRM - Basic Functions - Pricing - Define Settings for Pricing - Create Condition Tables - CUS701

the same errors above are again viewed.

The table "CNCCRMPRCUS701" is also not created.

Please help in solving this issue.

Thanks for your assistance in advance.

Best Regards,

Arun.

[Former Member · Accepted solution]

Hi Arun,

Please check the Access Sequence in CRM system.

There should be some access sequence that is accessing condition table CUS701. Please identify and check for the fields in condition table 701 in ECC and CUS701. They both should have the similar fields and similar key fields. If not make them alike.

-

---

OR -

---

If table CUS701 in CRM is not holding any values or not being used, delete it from the access sequence.

Then run the load ... it should work..

Pls award point if it helps !

Thanks

Vikas

[Former Member · Accepted solution]

Thanks a lot for your response Vikas.

It was very helpful.

Best Regards,

Arun.

[Former Member]

The problem is still there.

[Former Member]

The issue is solved temporarily.

Edited by: Arun Sankar on Jul 16, 2008 1:39 PM