About PI7.0 installation

[Former Member]

Hi all,

recently I did pre installation and post installation . I have done one sample file to file scenario but when I put the file in the server it is picked but output file is not generated.

and in SXMB_MONI it was showing this message <b> No messages available for selection </b> .

And I was checked in Message Monitoring it was showing an error

<b> Error Category XI_J2EE_MESSAGING_SYSTEM </b>.

can any one slove my issue....

Thanks in advance

With Regards,

Srikanth.

[Former Member · Accepted solution]

Hi,

Try stopping and starting the service for file adapter from Visual Admin.

This should solve the issue.

Regards,

Riyaz

[Former Member]

Hi,

Check whether you have any error in the sender communication channel error.

Try to test the scenario first in the integration directory by following the path Tools--> Test configuration where you can test the scenario by providing the payload and the service and the interafce details.

If this works then try to test the scenario by droping the file in the respective directory.

Also check whether the source and the target datatypes match with each other.

please reward points

Regards,

Nithiyanandam

[Former Member]

Hi Naidu,

first thing try to refersh the cache and perform component test

Run the report RSXMB_ACTIVATE_ICF_SERVICES from SE38.

Retry after some time after running this report. Or, try a restart of the J2EE engine after running this report

if found worth pls do the req

Thanx

Sampath