cancel
Showing results for 
Search instead for 
Did you mean: 

Write into HANA Cloud DB using SCI/HCI

Former Member
0 Kudos

Hello Friends,

I am working on a scenario where I will be fetching some data from on-prem ERP system and then write into a Table in SAP Cloud Platform. I have created a DB Schema in HANA Web Development Workbench and created a Table.

In this case what should be adapter type for receiver SCP system and how should I configure the same to ensure that the entries are written in the Table directly.

Your suggestions will really be helpful.

Regards

Amitabh

Accepted Solutions (0)

Answers (1)

Answers (1)

architectSAP
Active Contributor
0 Kudos

Hello Amitabh,

If I understand your requirement correctly, then this is a use case for a SAP Cloud Connector Service Channel.

Best regards

Frank

Former Member
0 Kudos

Hello Frank,

Thanks a lot for your response. I am sure this is one of the way to talk to the HANA Cloud DB. This one is using HANA Cloud Connector.

In my case, I wish to send an IDoc from ECC to HCI and the IDoc content will be written into HANA DB Schema. I am able to send my IDoc to HCI but not sure how the same can be put into the cloud from there on.

Regards

Amitabh

architectSAP
Active Contributor
0 Kudos

Hello Amitabh,

If you like, please have a look at this blog series by bhavesh.kantilal:

HCI/HCP-IS: IDoc Adapter Deciphered – Part 1 – Trigger IDoc from SAP ERP to HCI Using Basic Authenti...

Best regards

Frank

Former Member
0 Kudos

Thanks Frank. I am referring to the same blog to shoot the IDocs from ECC. I just need some help in defining the receiver adapter for SAP Cloud Platform.

Regards

Amitabh