Skip to Content

C4C Error when we try to simulate a Sales Order: No measurement unit is assigned to ISO code ZST.

Hello SAP Community!

We are facing this error when we try to simulate a Sales Order in C4C:

(DEVCLNTXXX) No measurement unit is assigned to ISO code ZST.

no-measurement-unit-is-assigned-to-iso-code-zst-is.png

But I have already assigned the ISO code PCE to the ZST on the MeasureUnitCode mapped on the CODE LIST MAPPING.

code-list-mapping-1.png

Also I have mapped it on the QuantityTypeCode on the CODE LIST MAPPING.

code-list-mapping-2.png

*DEVCLNTXXX, the Communication System ID for our S/4 Hana system

We are integrating Hybris C4C with S/4 Hana through HCI

Thanks in advance!

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Feb 16 at 01:36 PM

    Dear Juan Carlos,

    Kindly refer below links,

    SCN1

    SCN2

    Make sure that you have adequate ISO codes maintained in ERP.

    Regards,

    Shivanand B H

    Add comment
    10|10000 characters needed characters exceeded