Equipment related issue

[Former Member]

Inspection lot created with inspection lot origin 14(equipment)

after result recording when i m trying to save the lot the error i found CODES A DOES NOT EXISTS IN SELECTED SET 01,i checked the task list inspection key has been assigned with 300 type and catolgs and selected cheched for release everythinng is ok,even i checked the configuration for code A with selected set for 01 and this error is only with 1 plant,also check by using different selected set of different plant but same error occured

Plz help to solve this issue

Regards

Kunal

QM-Functional

[Former Member · Accepted solution]

Hi

It seems this issue not related to Equipment master. Could you pls check Catalog codes are maintained for particular plant and selected set 14 -14 Calibration inspection (PM/QM)?

You may check in SPRO->Quality Management->Quality Inspection--->Inspection Lot Completion>Maintain Catalogs for Usage Decisions--> Edit Selected Sets

Or check Selected Set in the same plant indicator is set for inspection type 14.if its not set, then you may select other plant catalog codes.

Let me know if you need any more information

Jeny

[Former Member · Accepted solution]

Thnxs 4 response

i had checked in spro selected is in released and code is also assigned,now i dont undersatand below statement

Or check Selected Set in the same plant indicator is set for inspection type 14.if its not set, then you may select other plant catalog codes.