Backflushing Error

[Former Member]

Good evening,

I am trying to Backflush a Fin product and I am getting the following message in COGIA report: -

The repetitive manufacturing profile is set for the reporting point procedure. However, either no reporting points exist for the material or they are incorrect. Two common reasons for this are:

u2022 The repetitive manufacturing profile has been changed in the current session.

u2022 You have not defined any milestone operations in the routing.

u2022 When creating the product cost collector, no reporting points were created.

I am a bit little bit puzzled on this,

What should I check?

Thanks in advance.

[Former Member · Accepted solution]

Hi,

In material master check the REM profile in MRP4 view. It should be 0001 - Auto cost collector,w/o activity backflush.

In your case Reporting point backflush profile is assigned. If you want to do RP backflush, in the routing assign Milestone confirmation.

And for RP backflush, in MFBF screen make tick mark in RP backflush. So for each opn wise you can confirm.

Regards,

Dharma

[former_member335796]

Hi,

What is the Error No.?

Regards,

Siva

[Former Member]

Hi Guy,

Can you please give in detail what is the error message you are getting, so it will easy for us to understand. Have you checked COGI errors if any exists.

For the scenario you mentioned, if you want to backflush finished product then you have to maintain control key in operation maintained in routing with setting for this operation as milestone operation & with automatic goods receipt active. Also check whether backflush indicator is active in material master record -

---

> MRP 2 view, according to the selection criteria either always backflush or according to settings in workcenter.

You need to maintain these setting for the backflushing.

Regards,

Avinash.