Skip to Content

identification Number must be numeric only go back and enter numeric number as identifion Number

I am getting this error, while I am accessing the inspection lot QA32 or QE51n for the Test Equipment calibration inspection lot

"identification Number must be numeric only go back and enter numeric number as identifion Number"

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Feb 09 at 04:36 AM

    Hello Sekhar,

    I think this is related to field from Inspection points when u do result recording.

    Please check inspection point config setting, may be this field is Numberic field, if yes u can only enter numbric values in it.

    Add comment
    10|10000 characters needed characters exceeded