Idoc error - basetype not found

38 Views

Hey,

I try to configure a netweaver system (aii) and a r3 to communicate with each other.

the aii system did not have the base type matmas01 to receive a material via bd10 from r3 to aii.

I only send a material with a number and that`s it.

I created a basetype in the aii with segment E1MARAM and the fields msgfn, matnr, mbrsh, mtart.

Is this enough?

Then I assigned the Zaidmatmas to this new created base type zmatmas1. I configured in WE20 the parameters for the partner profile and gave him a zmatmas1.

Then I sent a material via BD10, but it does not appear under the producs in my aii. why?

what else should i do to achieve this?

In my R3 I have a status 3 and a green light, but in the aii there never is an incoming idoc. (not even a failure msg, just no connection, although the rfc works properly)