Skip to Content

No active integration model found

Hi,

While I was trying to transfer the customer from ecc to gts I got this following message at SLG1 as "No active integration model found for filter object T_CUS/xxx Message no. XC142"

How to resolve this, can any one be helpful please.

Thanks,

Alex

1.png (18.1 kB)
1.png (17.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Feb 12 at 06:55 PM

    Hi Alex,

    I said it is weird because I have never seen these values in SLG1 in GTS, this is why I was wondering how you have been transferring customers from ECC to GTS.

    I checked in an available SAP GTS system a SLG1 log for a failed transfer of a BP and I have:

    - Transaction = blank

    - Program = /SAPSLL/SAPLCORE_APPLOG_SERV

    - Object text = SAP GTS: Business Partner

    Just to make sure: The SLG1 screenshot you sent is taken from GTS side right ?

    In your screenshot, the program mentioned is SAPLCIFG which makes me think that the CIF is somehow in the picture (see in your screenshot as well the Object text = Core Interface...). However, master data transfer from ECC to GTS does not use CIF but rather a mix of ALE and RFC.

    So, my guesses are:

    - May be you are looking at SLG1 logs but not in an SAP GTS system. Check SLG1 in SAP GTS or use the specific transaction to display the logs for transfer of customers and vendors (in SAP GTS too)

    - You have used the CIF... but the integration between ECC and GTS does not use the CIF

    Regards.

    Mouaz BEN REDJEB

    Add comment
    10|10000 characters needed characters exceeded

    • On ECC side, check if anything in stuck in the RFC pipe, using t-code SM58

      On GTS side, check if there is any dump, using t-code ST22.

      (Make sure you trigger the initial transfer of your customer to have up to date results in SM58/ST22)

  • Feb 08 at 01:19 PM

    Hi Alex,

    Could you please explain how you are proceeding for the transfer from ECC to GTS?

    I see in your screen shot of SLG1 that you have transaction XD02 and program SAPLCIFG which is weird in my opinion when sending mater data from ECC to GTS.

    Thanks and regards.

    Mouaz BEN REDJEB

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Mouaz,

      first sorry for the late reply. I am transfering the customer from ECC to GTS via (/n/sapsll/menu_legalr3) initial transfer of Mast. Data - Transfer customers.

      and then when I received the following message

      I checked in SLG1. Am I doing something wrong? please suggest how else I can send the customer to GTS.

      of course I have tried /n/SAPSLL/DEBMAS_DIRR3 and which is same as the cockpit.

      Also I was just curious why it is weired to see the xd02 and saplcifg ? could you please elaborate, so that I can correct please?

      Thanks,

      Alex

  • Aug 06 at 10:25 AM

    Thanks Mouaz. I am still a learner and made mistake. Thanks for your help.

    Add comment
    10|10000 characters needed characters exceeded