Skip to Content
avatar image
Former Member

MIC instead of every rolls

Dear All,

Order quantity is: 6000 YD, Total rolling quantity is: 6000 YD

in our inspection lot quantity is 150 YD on every Roll

in this inspection lot we have 6000 / 150 = 40 Rolls

Now we are doing result records by every rolls, we have 14 MIC under rolling dept to check/input the result records.

But some MIC like delta color we want this will do result records only when 6000 YD/40 rolls records is finished...

Is there any way to do this?

With B/R

Bishnu

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Feb 06 at 04:13 AM

    Hi Craig,

    Thanks a lot.

    Where I will set up this? If I set in routing it should also record for each roll.

    Do you meant it will under material specification i/o inspecting every rolls,

    if yes could you please advice me how I will do this?

    With best regards

    Bishnu

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 05 at 09:31 PM

    Not 100% sure I follow.

    It sounds like you have a MIC that you want to be a calculated type of characteristic. Color of first roll - color of last roll = delta color? Is that what you want? Your 14 mics are set up as individual results recording, one result for each roll. The last MIC, Delta color would be set up as a summarized MIC. With that, the system is only expecting one result.

    Craig

    Add comment
    10|10000 characters needed characters exceeded