Communication Channel in error

[Former Member]

Communication Channel in error though the error has been resovled. New files are processed succesfully !!!

CC still in RED.

I tried the basic steps which can change the status .( by deactivating the channel and activating the same , stopped and started the same ) . It resulted the same.

Thanks,

Karthik

[Former Member]

Hi

The communication channel is red because they could be other interfaces which are not working properly,it does't mean there is a problem with your interface,any one interface which uses this CC has an issue it will show red.Once all the interfaces which runs on this CC are running fine it will automatically turn green.

Thanks

[former_member240483]

Dont worry abot that it shows RED status for some time i e..next trigger...

Regards

Rao

[agasthuri_doss]

Hi,

>Communication Channel in error though the error has been resovled. New files are processed >succesfully !!!

Sometimes it will be in Error Status after few minutes it will turn to green in Color.

Regards

Agasthuri Doss

[Former Member]

Hi,

The Communication channel status indicates for all the communication channels available as working on adapter engine. If anyone of the communciation channel get failed not restricted to particula scenario or interface specific, then also the communication chanel status will be as RED.

And I believe when you will be seeing it in Component Monioring ---> Adapter Engine status will be of RED.

Don't worry it will not affect anything with your scenario which is working successfully.. Just to be onsafer side just observe the all detail status of the message processed successfully in CC

Thanks

Swarup

[GabrielSagaya]

some of the communication channels contains errors, you must check anything missing in your communication channels. after resolve the errors you can get green there

[Former Member]

The information that is displayed for the status of a channel on the individual cluster nodes is status information that is accumulated to give the overall status of the channel in the table of communication channels.

If the cluster nodes have at least one status that is above all other statuses in the status hierarchy, the channel receives this status as the overall status. The possible statuses correspond to those in the table of communication channels and have the following hierarchy: (red), (yellow), (green), and (gray). A combination of green or yellow with gray is not possible.

○ The information displayed for the processing entries of the selected cluster node is current runtime information on message processing. You get to Message Monitoring by selecting the message ID displayed.

Depending on the adapter used, the type and occurrence of the information here can differ. The information forms the entry in the Processing Errors column in the table of communication channels. The newest result is taken from the table of the cluster nodes.

○ The information about channel administration displays when and by whom a channel was previously started or stopped. You can only start or stop a communication channel for an entire server cluster, not on individual cluster nodes. However, since errors can occur on individual cluster nodes during the execution of these actions, error information is also displayed for each cluster node.

○ If the channel is controlled by availability times, the Availability Times tab page is displayed. All other availability times that are relevant for this channel are also displayed. You can exclude specific availability times and, if necessary, reschedule them.

Since only active availability times are displayed, it is possible that availability times do exist for the selected communication channel even if none are displayed.

○ The information on the Settings tab page displays how often an attempt is made to send messages to this channel, and at what time intervals.

The default settings are taken from the outbound properties for the J2EE service SAP XI Adapter: XI. You can overwrite and save these values. You can also restore overwritten values.

Information about changes made to the settings is always displayed.

The Settings tab page is only relevant for receiver channels and is therefore only displayed for channels of this type.

regrads

chandra

[former_member181985]

Hi,

Basically it will show the status of the channel from past half an hour (or) one hour. So even if your channel is working properly it will show as RED.

Check after 1 hr and letus know if you get the same status.

Thanks,

Gujjeti