Unavle to import IDOC using IDX2

[Former Member]

Hi Every body,

I am trying to import the IDOC for XI Metadata purpouse.

I have imported sucessfully : DEBMAS06 , CREMAS04 , ADRMAS02 , MATMAS05

But not able to import : DEBMDM05 , DEBMDM06 , CREMDM04

I have maintained port in IDX1.

When i import above IDOCS it shows below error:

I::000

Message no.000

kindly put u r views on this

with regards

Srinivas

[Former Member · Accepted solution]

Hi,

you should check your (in idx1) configured RFC connection in sm59.

Try: Utilities -> Test -> Authorization Test

Regards

Patrick

[Former Member · Accepted solution]

Hi Thx there was some authorization problem

regards

Srini

[GabrielSagaya]

If there were any changes made to the structure since first being loaded into the idoc metadata cache (IDX2), then the structure will be out of sync. In this case you would have to delete the relevant structure in IDX2 and either manually load it or let it load automatically at runtime.

[Former Member]

hi,

1)Go to IDX2 in XI system and import the Idoc. If it exists,delete it and Reload.

Also make sure that,IDX1 entry is correct.

If you are in PI 7.0 then you can try this-

http://help.sap.com/saphelp_nw04/helpdata/en/44/11982eb8da648fe10000000a1553f7/frameset.htm

2)Please ensure that all the segments are released.

Also you can check the IDOC via we30 by F9 (check).

3)There could be a problem with the RFC destination defined within the IDX1 port. So first test the RFC destination using SM59.

Also ensure that you have used the right naming conventions for the PORTS and RFC destinations as below:

<SID>CL<ClientNo> e.g DXXCL055 where DXX is the SID and 055 is the Client No

regards

chnadrakanth