i have a problem when I run the DTP

[Former Member]

hello

the day before , I load data in a PSA "MASTER DATA" mode full,

then in the morning I load data again this "MASTER DATA."

I can see that the same lines do not not present a problem but the lines were changed, i have a problem when I run the DTP?

I get this messages errors:

.« the time interval & (from/to) for the data

ecords 1 & and 2 & overlaps in characteristic 0COSTCENTER &.u201D

u201CMessages for data records saved; request is red acc. to configurationu201D

«

best regard

francoise dinatale

[Former Member · Accepted solution]

Are you running Full DTP with no previous requests deleted in the PSA again ?

Either run Delta DTP to load only new requests or Set "Handle Duplicate Records " in DTP Update Tab.

[Former Member]

Hi Beekay

When i want activated, I have this messages 😘

Overlapping selection criteria with DTP DTP_D3FKTM21ZX4Y81NT93FOIY6IZ (field )

Best regard

francoise dinatale

[Former Member]

As this is a master data load, the attribute change run is mandatory before performing the next load.

The probable reason for this is in the master data table there is an entry for a characterisitic value and the load resulted in another value. The difference between these two records is the object version. Exisitng record will have A version and the changed record has M version.

So when we active master data(attribute change run ) then M version overwrites A version and hence on a net we have only one record in master data table.

Post the above task if we again load master data, as is in your case, then the record will find its place in M version.

As the activation is not performed(probably), the system finds it difficult, with previously loaded M version and currently loaded M version and hence the reason for the message.

Naveen.A