Skip to Content
0
Former Member
Jun 03, 2008 at 10:05 PM

Disassociating the BSP application from the Enhancement Set for a Component

44 Views

Hey Folks,

I created an Enhancement Set and Enhanced the Component TPMOE using this Set. When prompted for the BSP application during the enhancement of the component using the Enhancement Set, i used an existing BSP application instead of creating a new one. Is there a way this act can be reversed in order to have a new BSP application hold the enhancements for the corresponding component.

The problem currently is that the existing BSP application was once used earlier to enhance the same component after which the Enhancement Set was deleted. And now this BSP application object already has the Controller and View objects corresponding to the view which I want to currently enhance. Hence there is a conflict when I try to enhance the views. For example , when I try to enhance the view HeaderEOF, I get an error message stating that the mime object already exists for HeaderEOF.htm.

In order to resolve this I would like to point all the new enhancements to a new BSP application.

Please note that the state as of now is that an enhancement Set has been just associated with the component and no enhancements have yet been done on any of the objects belonging to the component. Hence it would be safe to start the enhancements which will be collected in a new BSP application.

Thanks and Best Regards,

Puja.