Skip to Content
0
Former Member
Jun 03, 2008 at 03:54 PM

Table Column Auto-Resize Problem

73 Views

Hello All,

I have a model set up where I have 8 tables, each with a signal out, based on 'select' , selected line only, passing a single field (material). These 8 outputs all then go into a single datasource, which has an output table. I have designed this table so that the columns are not evenly spaced (e.g. more room for material description, less for unit of measure). When I run the model, initially, the table looks correct then after a few seconds, the columns all rearrange themselves to be evenly spaced across the width of the table. When I remove all the inputs to the datasource, the table displays correctly (but of course, empty of data!)

The table rearranges itself even with only 1 of the 8 outputs connected. The outputs are from a nested iView. All the datasources used are from BW queries & views.

Does anyone have any experience of this very annoying problem, or know what could be causing the issue?

Many Thanks,

Richard.