Hi
We have a situation where we have a mature Payroll system (has been running since 2004).
We now want to interface some Payroll results to a new Penison Provider and are using PU12.
The system came into effect on 1st May 2008. In order to provide a base run we ran the Interface for April 2008.
However, we now have the situation were the Interface is including retro values, which should not be included.
For a particular employee, for example:
April Payroll
Retroed back to March 2008.
So when we ran the Pu12 it stored March & April Results.
May Payroll:
Retroed back to January 2008. (Although note that there was no effect on the Payroll Results - in other words the values of the January in May run were the same as those in the January in January run. Therefore there was no effect on the payslip for May.)
However when we ran the PU12 for May it picked up the results for May which included results for January and February. And when it checked for differences it produced values for January and February (because there were no previous PU12 results for these months, when it compared to the previous PU12 (April) results.)
Therefore the values in the May PU12 interface were three times the expected values.
So, my question is how can we initialise the PU12 so that only produces values that correspond to the actual Payroll.
Regards