Massive closing of WO

[Former Member]

Hi,

when i try to do the massive closing by CO99 it perform the task and showing the status CLSD set.

but when i display all the orders using iw39 its showing the status as TECO itself not showing CLSD status...

Why its like that???

Edited by: EBIN JOSEPH on Jun 3, 2008 2:52 PM

Edited by: EBIN JOSEPH on Jun 3, 2008 3:04 PM

[former_member187991 · Accepted solution]

hi

i think you have not settled the order, before settling if you run the T code CO99 system will try to do the business completion ,since your order balance is not Zero ,system will not allow to do so

hence system will Teco the order and save it

also if you again try to execute the CO99 you can find the order number in the error message saying order balance is not ZERO

regards

thyagarajan

[Former Member · Accepted solution]

hi,

but when i try to do the closing manually its getting closed without any message/problem.In CO99 its showing the message status CLSD set for the order..but when i display the order thr iw 39 its TECO only ..not closed

ebin

Edited by: EBIN JOSEPH on Jun 4, 2008 7:29 AM

[former_member187991 · Accepted solution]

hi

whether the status CLSD has seen in the order status after manually closing ,check once again ,if it can be closed manually then in CO99 it should be closed without any problem

regards

thyagarajan

[Former Member · Accepted solution]

hi,

if the residence time is 0(zero) Whether system will close the orders that have been TECO today or it will take the TECO orders upto yesterday???

Regards

Ebin

[former_member187991 · Accepted solution]

hi

may be i am not sure ,just check it in ides,i think it will take the order which is completed today when you specify as 0 in residence time

regards

thyagarajan

[Former Member · Accepted solution]

Hi Ebin

The residence time is the min no of time in days for which the work order is residing in the system for ex if you are giving the residence time as 10 (& today is 20th), then the system will do the CO99 for those orders which have been raised before 10th.

I hope you are doing these steps in CO99:

1. Entering the plant

2. Enter the order type

3. Remove the tick u201CWith CO Production ordersu201D.

4. Tick u201Cw. plant maintenance ordersu201D

5. Put the residence time as 0.

6. And then first do the test run before actual run

Thanks

Anish

[Former Member · Accepted solution]

Hi,

if residence time is 0(zero) system will close the orders upto yesterday only.

but system is just showing that the order is closed.the message is as below in the message log after CO99.

I KO 392 1 1 800256 Order 800256: Status CLSD set

but when i take the particular order its status is still TECO. and can be manually closed also.

Can u suggest a solution to sort it out?

thanks

ebin

[Former Member · Accepted solution]

Hi all,

Thanks to all.

As Mr Anish told when i unchecked the test run the orders have been closed.

I have awarded points to all.

[Former Member]

Refer note 707105 for this behaviour

Regards

Sreenivas