Skip to Content
0
Former Member
May 31, 2008 at 11:11 AM

Basic Doubt

25 Views

Hi Let me put of m y Scenario , kindly advice me if those are correct:

In SLD i have two Business System for instance : ERPSRM and ERPBCK

Now i design appropriate DT , MT , MM , IM in our IR all fine here\

Next i Cinf in ID : Here BS : ERPSRM is given cc Sender File Adapter

BS : ERPBCK is given cc Receiver RFC Adapter

now when i place the file in the FileSystem , ERPSRM picks up the File and does the mapping and gives out the Target interface after mapping program.

My Question :

I could see entire steps of the message processing in my "SXMB_MONI" of the PI system ? am i right ?

No need to login into the respective system ERPSRM and ERPBCK to check their sxmb_moni to see message of Outbounb and Inbound interface right ?

Well what are the steps i could check in the SXMB_MONI

When i see in my scenario i could see

1)Inbound Message (To PI ) which means it came form the BS : ERPSRM

2)Redeiver Grouping : Here i guess mapping would have occurred

3)Response : here it would have reached the end in terface

is my undertabding is correct , only these steps are there here .

Well in Inbound Message / Receiver Groupng --> i could find the "Payload"

My understanding was after Response should have the payload of my target Interface after mapping, but i see nothing but in rest two "Inbound" and "Receiver Grouping" i see payload of the Source Interface.

Is this normal ??? if so where could i see my : Target interface xml after mapping

Kindly Help

Srini