Skip to Content
0
Former Member
Jan 07, 2008 at 09:32 PM

install / upgrade from CR XI to CR XI R2 problems

15 Views

Post Author: xaviervp

CA Forum: Deployment

I just downloaded CR XI R2 which I needed to be able to connect to SQL 2005 using the native client

after I installed I ran it for the first time and it went through the usual configuring cristal (similar to when you run an office app for the first time with a new user on a workstation) this is fine I went in modified one of my test reports then I exit Crystal, well when I opened Crystal again it went throught the configuration routine all over again, it does it every time I open Crystal this is a waste of time takes about 5 min each time.

is this normal or is there something wrong on my install...

Thanks

Xavier