Print out of Layout

[Former Member]

Hi,

Need suggestion for getting print out put of GRN (in MIGO), Invoice verification (in MIRO) & service entry sheet. Request you to suggest on this.

Regards,

Ranjan

[former_member218067 · Accepted solution]

Hi,

GR Printout MB90

Set up message determination for material document ,IV and service entry in spro

maintain condition record MN21

IV printout MR90

service entry sheet ML83

Condition MN13

BR

Diwakar

[Former Member]

Hi

Edited by: Archit Gandhi on May 29, 2008 4:51 PM

[Former Member]

Hi

Check following are some of steps for GR collective printing from SDN only

1. Maintain the Printer Name in SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Printer Setting

2. Ensure that in SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Item Print Indicator, 1 stands for Matl Doc print out

3. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Print Version, maintain Print Version 2

4. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Maintain Print Indicator for GI/Transfer Posting Documents

5. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Output Determination->Maintain Output Types, for the Output types WE01, WE02 and WE03, ensure the foll:

a. Default Values: Dispatch Time is 3 or 4 as per reqmt. and Tr medium is 1

b. Print Parameter is 7

6. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Output Determination->Printer Det->Pr Det by Pl/StoLoc, maintain the Output device for all your Plants

7. Go to MN21, for Tr Type WE, Print Version 3, maintain Print Item as 1.

Now the settings are ready for Printing Material doc

8. While doing MIGO, ensure that in General Tab, you get "3 Collective Slip" beside the Print Indicator and you tick mark the field.

9. Now depending on the setting in 5a, the Matl doc is printed. If it is 3, you have to print it using MB90. If it is 4, it is printed immediately.

Regards,

Archit