ZM400 Configuration problem

[Former Member]

Hi Gurus,

We have two problems with the Zebra ZM400, that we use to print label in the MIGO for movement 101:

1. In the moment that the Zebra print isn`t cut the label... we think that the printer driver could be desconfigured.

2. When we ask for more than 1 label (in the WE position) the Zebra print x^2 labels.... when we check the spool the view is correct, but in real it´s not.

Which can be the problem??? Somebody knows????

Thank you in advance!!!

Noelia

Edited by: Noelia Río Gómez on May 27, 2008 1:12 PM

Edited by: Noelia Río Gómez on May 27, 2008 1:38 PM

[Former Member]

Hello, we actually found the solution:

1. With the cut problem we put into the code ^MMC, example:

...(^{DFE:prueba_a.ZPL}FS

/(_TA000JSN^LT0MMT^MNWMTT^PONPMN^LH0,0JMA^PR2,2MD10^LRNCI0^MMC...

2. With the number of copies we put into the code ^PQ when really it´s no necessary because SAP bring the number of copies to the Zebra automatically.

Anyway you can find good information about it in the following guides:

ZPL II Progaming guide

Zplguide_10

Zplguide_14

And if you want to upload images, graphics, etc, you must do it with ZebraNet Bridge Enterprise, it´s the best way to make changes and control the printer. In the ZebraNet Bridge Enterprise user guide you have the complete explanation.

I hope that it could be ussefull for someone.

See you

Noelia