05-27-2008 9:45 AM
Hi all,
i am sending an idoc through ALE, the idoc is successfully sent from the sender's system but in the receiver's system it shows partner profile is not available, but i checked in we20 the partner system is there.
So, can any one help me out of this...
Or any clues where the problem may be will be rewarded.
with Regards,
Syed
05-27-2008 12:59 PM
Hi,
Guess u can try this.
-Use transaction we20.
-Select the Partner Profile types for Incoming Idoc.
-Create Partner No, Speficy Message type in the Inbound Paramerters table control
-Specify the Process code for the Message type.
Revert back if any queries.
Reward points if useful.
Thanks
05-27-2008 9:53 AM
hi ,
check in tcode bd 64 crate model view and add message type then click enivironment generate partner profiles give ur message type and give reciver port id and execute the port will be assigned
if problem exist again after that go to tcode we05 in ur reciver client and note idoc no and give it in we19 and click inbound function module and assign the function module name now the data will be transfered
if useful reward points
muthu.
05-27-2008 9:58 AM
Hi,
Go to T.Code : WE20, select the appropriate Partner Profile types for Incomming IDoc.
Create Partner No, Speficy Message type in the Inbound Paramerters table control, and specify the Process code for the Message type.
Check now by creating an O/b Idoc and verify whether the I/b Idoc is created in another system.
Regards,
Anbalagan
05-27-2008 12:59 PM
Hi,
Guess u can try this.
-Use transaction we20.
-Select the Partner Profile types for Incoming Idoc.
-Create Partner No, Speficy Message type in the Inbound Paramerters table control
-Specify the Process code for the Message type.
Revert back if any queries.
Reward points if useful.
Thanks