Skip to Content
avatar image
Former Member

VPRS: Error

Dear SAP Guru;s

I am facing problem in the detremination VPRS condition type.

I have never seen this error.

When I see the order documents it is not showing VPRS Condition Type.

In the Billing screen Conditions it is showing 10 -15 VPRS with red indicator and Value Zero.

I can als see in the Analysis the Error is "Error in Auantity/Value Determination."

How Can I rectify the error.

regards,

Amlan Sarkar

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    May 21, 2008 at 07:27 AM

    Hi

    Please check the MMR whether the VPRS Cost is standard or Moving average. If standard whether the values are maintained in MMR. If Moving average, then the system gets the value from Info records and the problem could be from MM side.

    This is only a clue....

    Thanks,

    Ravi

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 21, 2008 at 07:30 AM

    Hello,

    please check if you hava more than one VPRS in your pricing procedure.

    In this case it is normally that the VPRS is zero.

    For technical reasons, after determining the first cost, the system sets

    the value from the goods issue document back to '0' so that the

    subsequent costs are also given the value '0'.

    When pricing is carried out again, the cost is taken from the material

    valuation segment.

    In the stardard system, only one condition category has been provided

    for the costs (condition category 'G').

    Set up your pricing procedure in such a way that only one cost occurs.

    If you have only one condition with condition category please

    check if the correct cost appears after pricing is carried out again.

    I hope that the information are helpful.

    Regards

    Claudia

    Please don't forget to give Reward Points if you are satisfied with the answer.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 21, 2008 at 11:33 AM

    Thanks All for your Input.

    There was Item cATEGORY GROUP FOR THE MATERIAL WRONGLY cONFIGURED.

    regards,

    Amlan

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hello,

      I am facing the same problem.

      Could you tell me what was wrongly configured in the item category?

      Best Regards

      Jens

  • avatar image
    Former Member
    Jan 19, 2009 at 01:21 PM

    Hi Amlan,

    I am facing the same error and have checked all the possible enteries. Can you please tell me how did you solve the problem.

    Rgds,

    Antima

    Add comment
    10|10000 characters needed characters exceeded