Skip to Content

Recovery in Data Services

Hi,


Maybe you can tell me which train of though is right...

When I enable recovery it will :

recover the whole workflow irrelevant where the issue was

or it recovers where the issue occured ?

Thanks in advance,

Kolo

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Feb 01 at 02:49 PM

    Hi Kolo Toure,

    During recovery mode, the software retrieves the results for successfully completed steps and reruns uncompleted or failed steps under the same conditions as the original job.

    Also in case if you are using try/catch block, the software considers steps that raise exceptions as failed steps.

    Hope this clarifies your doubt.

    Thanks

    Add comment
    10|10000 characters needed characters exceeded