Position

[Former Member]

What config is required to make sure that you can not employ more than one person in a position.

Currently, the set up brings up a delimit position option in hire action

[Former Member · Accepted solution]

Hi,

You can maintain the Staffing Percentage for the Position while creating the object, then maintain the 100% for relationship A/B 0008 between Position & Person.

Good Luck

Om

[Former Member]

hi

what om said is right

all the best

Edited by: madhu sudhan on May 16, 2008 8:30 AM

[Former Member]

Guys

Thanks for your quick replies

I verified the data and see that the Person to Position rel (b008) is @ 100%. Despite this, I am able to hire another person into that position.

There must be some setting in IMG to make sure that you can only hire one person to one position

Matt

[Former Member]

hi..

After making relationship as 100% u can only hire a person on the same position with different dates only and after delimiting the previous one..

Reward me if useful

Thanks

Sheetal

[Former Member]

Can some one please help me on this topic!

[Former Member]

Hi,

in table V_T777ZVK set the time constraint for relationship A008 between object S and P to '2'

Wilfred.

[Former Member]

Dear Matt,

Check these settings, you must have the relationship between S to P & P to S as 100%, that is A008 & B008, here A denotes Passive relationship & B denotes active relationship.

In a Org structure, Person holds the Position that is Passive type of relationship. If you need to restrict both the relationship to 100%, you need to maintain relationship as 100% for both A008 & B008.

The time constraint between S & P must be "2", so that at a time only one object can be maintain.

Good Luck.

Om.

[Former Member]

Om

I see A/B 008 relationships are @ 100 %.

I have maintained A008/B008 for Infotype 1001 as Time Constraint 2. But it does not help .. same issue continues

Is there any other setting I need to make

[Former Member]

Hello,

Have you tried using the user exit?

Put a condition in PA user exit for checking the position.

You can use EXIT_SAPFP50M_002 exit for your requirement.

Regards,

Manoj.