Skip to Content
0
Former Member
May 13, 2008 at 02:56 PM

PO Quantity Rounding

124 Views

Hey All,

I needed some help trying to figure out the rounding logic which SAP applies for PO quantities when we create a PO though me21n or an interface.

I am creating a PO thru ME21N. I enter a material A( for which the rounding value is set in the material master). The PO UOM is different that the Material master UOM. So I think it first converts the value i enter to base UOM and then applies some logic using the rounding value to calculate the quantity. By debugging I found out that it uses 'MD_SINGLE_ROUNDING'. What is the exact logic?

Any input is highly appreciated.

Thanks,

Aparna.