Material can be deleted in CJ20N even if PR, PO exists

[Former Member]

Hi Gurus

In CJ20N even if the codified material contains PR,PO system allows to delete the material from CJ20N.Kindly suggest me some solution to this problem

Regards

Thanks in advance

Abhijit Sen

[varshal_kachole3 · Accepted solution]

Hi,

Try this:

1. Tcode :OPSG Component Tab, delete section mention Error instead of Warning..

2. Assign this to Tcode :OPUV

Or try User exit:CNEX0039

Hope it helps.

Reward points if useful.

thanks..

[Former Member · Accepted solution]

Dear Mr Varshal

Do i need to write some logic for CNEX0039 or just ask ABAPer to apply it

Regards

Abhijit Sen

[Former Member · Accepted solution]

U need build the logic based on ur business requirement.. Based on ur business logic...Abaper will write the programe in using this User Exit.

Hope this helps.

Venkat

[Former Member]

Hi,

Refer a similar thread. It may help you:

Regards