Skip to Content

Getting Deploy Error when using the WebDynpro Compiler

Hi,

I have a VC application which uses the RFC from R/3.

When i am using the Compiler as WEBDYNPRO, it is giving me Deploy Error as:

WebDynpro Compiler:

Portal request failed

(Model properties Namespace and Vendor are not specified for source archieve generator)

Also,

I checked the Iview property in the Portal but i am unable to find this properties.

Guide me when and where this Complier type is uesd..?

Thanks & Regards,

Dhruv Shah

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 13, 2008 at 06:32 AM

    Hi Dhruv,

    These are the properties of the model itself. You need to be in the model level (in the design board), then click on the configure button (on the right pane). You'll get a property editor where you need to add properties (from a preconfigured list). you should add these 2 properties and set a value to them.

    Regards,

    Natty

    Add comment
    10|10000 characters needed characters exceeded

    • Hi,

      I am unable to find this properties.

      In the Model View i searched a lot.

      I have another question also.

      Do you know how to refresh the table from the RFC.

      Thanks& regards,

      Dhruv Shah