KONP-KBETR is not correct when it is %

[Former Member]

Hi guys,

I create a condition type and it is %. When I went into defining the condition record, I put the rate as 10 and unit for this is %. In other words, this will be 10%.

However, when I check in KONP table, the rate shown under konp-kbetr is 100.

But if use rate instead of % , say 2357, then the kbetr is showing 2357.

Any idea why it is not showing 10 but 100 when it is percentage based condition type ?

( The way I checked the table is :

take example the condition table is 305, I went to A305, find the KNUMH, then use the KNUMH in KONP, then look at the KBETR)

[Former Member · Accepted solution]

This is correct the system stores percentages in tables after multiplying by 10.

[Former Member · Accepted solution]

This message was moderated.