Skip to Content

Lumira Discovery and BIP- Document with 2 stories crashes when selecting second story

discovery-error-message-4.jpgbip-error-message-1.jpg

Lumira Discovery and BIP- Document with 2 stories crashes when selecting second story after Query Panel edited --

Lumira BIP and Discovery --2.1 SP00

BI Platform 4.2 SP3

I have a lumx with a single UNX data source. It has 2 stories, each with filters. In Discovery and BI Platform I get the same behaviour, although with different error messages (see attachments) The following workflow produces the error:

Open document Refresh Select second story Error is produced I created a test document to replicate the issue and it behaves slightly differently.

Create document Import data Add visualisation to Story 1 Create Story 2

Add Visualisation to Story 2 Save and Close Open document

Can switch between Stories ok Add filter to Story 1

Error is produced when selecting Story 2

The common factor seems to be that the Data Source is edited (new object added or similar) after first being built. I created another test document and it can switch Stories with filters just fine based on the initial fetch of the data. Once I edited the Data Source and added another object, it failed immediately when selecting Story 2.

Please see attached image

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Jan 18 at 12:16 PM

    Hello - is this Lumira Discovery 2.1? If not would you please update? Are you on version BI4.2 SP05?

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 18 at 12:19 PM

    Hi Tammy,

    Yes this is Lumira 2.1 SP00 both Discovery and BIP, 4.2 SP3. I will update the Question. Thanks.

    Add comment
    10|10000 characters needed characters exceeded

  • Jan 18 at 01:24 PM

    Hi All,

    I ran into this information while searching for a solution online. Please can anyone confirm that the restriction below still applies to lumira 2.1.

    • Once a LUMX document is edited using the designer component, it cannot be edited in the discovery component. The LUMX file can be opened in discovery and viewed, and the offline data can be refreshed using discovery – however the visualizations and stories cannot be modified. This restriction is planned to be lifted in a future release.
    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 06 at 02:18 PM

    Hello,

    I have the same issue with a .LUMX file. Is there a possibility to get the data.

    I have spent much time in the report and don't want to make it new from the beginning.

    Greetings!

    Add comment
    10|10000 characters needed characters exceeded