Skip to Content
avatar image
Former Member

IDoc sender question

Hi,

I have a question?

Suppose there is an Idoc configured to be sent from ECC system to XI. Lets take ORDERS03 or DESADV03. There are multiple scenarios which are configured to read the same Idoc. How does Idoc figure out to which interface it has to go?

Regards,

Anirudh.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • May 12, 2008 at 09:11 AM

    At XI u can have only one Sender System + Sender Interface pair

    Although u may configure many receivers for it in receiver determination

    Regards,

    Prateek

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 12, 2008 at 09:14 AM

    Receiver determination step will be executed after reaching the IDOC to XI system.You have to specify the sender message interface and namespace in Receiver determination.

    Basing on that IDOC goes to the particular reciever detrmined in RD step.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 12, 2008 at 09:18 AM

    Hi Anirudh,

    In XI, for a ECC system with a client, you can have only one sender interface for a particular IDOC and you can have multiple receivers for it but in the same scenario. So you cannot have multiple configuration scenarios in ID in XI for a single IDOC of a ECC system for one client.

    Regards,

    Rajeev Gupta

    Add comment
    10|10000 characters needed characters exceeded