Skip to Content
0
Former Member
May 08, 2008 at 04:03 PM

problem with smartform table node

18 Views

hi i am working on smartform,

requirement is to put lot of barcodes , with a horizontal line separating them,

so i felt, displaying a table pattern inside a loop was the way to go,

but when i am setting table parameters in the details part,

i was giving the following and it was giving error saying

the width of matnr and barcode doesnopt correspond to the total width of the table

the total table width is 16 CM,

MATNR 15.50 MM 30.50 MM

BARCODE 15.50 MM 30.50 MM

what ever value i am giving in these columns, it continuosly giving errors,

if some budy has a sample parameters which worked with them, please give me,

i shal;l make necessary changes.

when i increase the table width it says doesnt fit in the page, page is DINA4 with portrait format.

please help.

rgds.