Skip to Content

Stuck Entries in outbound queue SMQ1

Requisition queues are handled in a serial manner, i.e. the requisitions created in backend are sent across to SRM

Through a queue (BBP_EXTREQ_TRANS) in a serial fashion. Because of this, when one requisition transfer fails and the

Requisition gets stuck in the SMQ1(outbound queue) it stops all the following requisitions from going through to SRM, i.e.

It blocks the whole queue.

One way of resolving this issue is going into the queue in SMQ1 and manually deleting the erroneous entry that is stuck.

Is there an alternative means of handling this issue such that one requisition getting stuck in SMQ1 doesnt stop the others from transferring over?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 01, 2008 at 02:36 PM

    I don't think there is any std approach, but you can run a periodic z program to store the entries of the required queue in some ztable and delete these queues using this FM QRFC_LOG_DELETE and proceed with the other instances.

    Regards, IA

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Rohan,

      I have seen a scenario where system was populating SMQ1 with errorneous enteries, but this did not affect all the following Purchasing Documents, it was specific to Purchasing document which was in error because of certain criteria.

      If you look details in SMQ1 it would give you data about why Purchasing Document failed, you can analyze that and fix this.

      Please refer to following OSS notes, this might helpful.

      675725

      361534

      510572

      575698

      1027506

      650333

      977734

      806165

      662383

      872533

      Regards,

      Manish.

      Note: Please reward Points if anwser is hepful