SMD SOLMAN SP15, no data is visible

[Former Member]

Hello,

I use SAP Solution Manager 4.0 with (ABAP SP15, BI CONT 703 Patch 9, LM-Service 14 Patch 3) and would set up the SMD functionality for SAP EP 6.40 SP19.

The Set up Wizards runs without any errors and I could see the data in all the steps (E2E Workload, E2E Change Analysis, E2E Exception Analysis).

Unfortunately since 2 months I can see any data in (E2E Workload, E2E Change Analysis, E2E Exception Analysis). The E2E_EXTRACTOR_CONTROLLER job runs without any problems

Here are my problems

E2E Workload Analysis

tab Overview

empty

E2E Workload Analysis

tab <SID> Portal is empty and contains only:

Conditions

Navigation

Metric Data Display

No Applicable Data Found.

E2E Change Analysis

Overview

No SID found for value 'E11 0020198811012003146909000001927' of characteristic 0SMD_FSRC

Invalid filter on 0SMD_FSRC: Filter changed

E2E Exception Analysis

Overview

Graphics Rendering Problem

Any helpful information will be appreciated

Thom

[Former Member]

Hi Thom ,

I am also facing the same error, could you please share your experience in this regard

It will be very helpful

[Former Member]

Hi!

The experience I made here:

you should also execute some actions on the sattelite systems, because the extractors from SOLMAN do not have any data.

[Former Member]

Hi Thom,

Thanks for your reply...

What actions i have to execute in satellite systems. Could you please explain in detail....

You can also explain in the thread E2E Workload analysis, no data available that i can give points also

regards

Naveen kumar

Edited by: Naveen kumar Palanichamy on Sep 23, 2008 8:44 PM