04-21-2008 11:11 PM
I have a customization table and I want to see which TCode puts data into that table. I already tried looking in SPRO but was not easy. Also tried using TSTCT etc. Is there a way I can see at system level which was the last time data was put into a table, by whom and using which program/TCode?
Or is there any other way
04-22-2008 5:23 AM
Hi,
This should make your search little bit easier. SM30---->table name which is maintained thru customization->Customizing---->Skip, It will display all the paths in customization where this table is being maintained. Of course you still need to go thru each path by double clicking on it but then atleast it's a limited search & much better than searching blindly in SPRO.
I hope this helps,
Regards
Raju Chitale
04-22-2008 2:21 AM
Hi
I am not sure if there is any means of doing this.
But can advise crude way:
Run Program RPR_ABAP_SOURCE_SCAN
and give Z* against Program Name
ur Table Name against Find String
check the result, if ur Table name appears with update/Insert/Modify keyword.
Hope it helps.
Thanks
Praveen
04-22-2008 5:23 AM
Hi ,
Using 'Where used list' you can get to know the program where the table is used. Check in which program 'INSERT' statement is used. From the prog you can find the tcode using again 'Where used list'.
Neelima
04-22-2008 5:23 AM
Hi,
This should make your search little bit easier. SM30---->table name which is maintained thru customization->Customizing---->Skip, It will display all the paths in customization where this table is being maintained. Of course you still need to go thru each path by double clicking on it but then atleast it's a limited search & much better than searching blindly in SPRO.
I hope this helps,
Regards
Raju Chitale
04-22-2008 5:25 AM
04-22-2008 5:30 AM
try to used ' where to used ' list option to find out the transaction for a particuler table ..