cancel
Showing results for 
Search instead for 
Did you mean: 

Idoc not reaching XI..

Former Member
0 Kudos

Dear All,

An Idoc is succesfully posted from R/3 dut it is not reaching XI

When the same Idoc is retriggered from we19 from R/3 it came to XI

Not getting any logic y its not coming at the actual run while the same is reaching XI pushing frm we19..while the ports for sender (R/3) and receiver (XI) are correctly mentioned..

Is there anywhere betting R/3 and XI where the Idoc get lost..

Please suggest why it is happening so?

- Pankaj

Accepted Solutions (1)

Accepted Solutions (1)

former_member859847
Active Contributor
0 Kudos

Hi,

could you please let me know the status in 'idx5".

warm regards

mahesh.

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi Pankaj

also check SM58 and BD87 in the sending system.

Regards

Mario

Former Member
0 Kudos

Since you are able to send the idoc via WE19 therefore it seems that there is some poblem in your partner profile.

What you can do is, go to we19 and after entering the idoc number, in the next screen double click on parant node of idoc. Now compare these setting with your partner profile in WE20 (double click on outbound idoc).

Former Member
0 Kudos

Hi,

i think you are triggering the particular Idoc using the Program kind of thing.

Make sure that all the Config things like Partner number , RFC destination all these settings are correctly mentioned in that program.

look into the program for the Issues

Regards

Seshagiri

Former Member
0 Kudos

Hi,

Check the following:

1) Test the RFC connection using SM59 in R3 it should point to XI system.

2) Check the port and partner profile using WE20 and WE21 tcode in R3.

3) Have u loaded the IDOC meta data in XI using IDX2 tcode.

4) Go to SXMB_MONI and check the message status and message trace.

chirag