Skip to Content

S/4HANA Readiness Check error No S User Passed

Hello,

We implemented all steps from SNOTE: 2290622.

The report has been started from Solution Manager 7.2: "AGSRC_START_ANALYSIS", but we're geeting a specific unknown error as below about No S User Passed:

2017.12.26 05:55:40 Extraction of DDIC appends entries has been started

2017.12.26 05:57:18 Extraction of 628 DDIC append entries has been finished succesfully

2017.12.26 05:57:18 Extraction of DDIC customizing includes entries has been started

2017.12.26 05:57:18 Extraction of 609 DDIC customizing includes entries has been finished succesfully

2017.12.26 05:57:18 Zip xstring created

2017.12.26 05:57:18 Start to collect transaction Object Directory information

2017.12.26 05:57:28 Transaction Object Directory information collected

2017.12.26 05:57:28 Start to collect transaction application component information

2017.12.26 05:59:59 Transaction application component information collected

2017.12.26 06:00:00 Start to send custom code information to Solution Manager system through SM_XXXCLNT500_BACK

2017.12.26 06:00:53 No S User Passed

2017.12.26 06:00:53 Job canceled after system exception ERROR_MESSAGE

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jan 23 at 08:38 PM

    No answer... but wanted to say that we have the same issue.

    By chance, any further progress on resolving this issue? Is there any further findings that are worth knowing/looking into that you can share?

    Many thanks in advance for your time.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 12 at 12:52 PM

    Hi all,

    we had similar problem ... solution was following:

    Check the user used in the RFC connection (visible in joblog, in your case SM_XXXCLNT500_BACK) on the system to be analyzed and make sure that on SolMan this user has a valid S-User assigned in transaction AISUSER ! This should be enough, but maybe worth to check if also your SolMan-user with which you are executing the analysis has a S-User assigned in AISUSER.

    br

    Thomas

    Add comment
    10|10000 characters needed characters exceeded