cancel
Showing results for 
Search instead for 
Did you mean: 

Quality Inspection

Former Member
0 Kudos

Dear Sir,

In MMBE lot is in Q.Inspection.But after doing QA32 the system shows the inspe.lot.But with RED signal. Why?

What setting shud be required for UD?

Urgent.......

Points will be rewarded.....

Thanksin advance

Accepted Solutions (1)

Accepted Solutions (1)

former_member698542
Active Contributor
0 Kudos

Hi Sonal,

The Inspection Plan might have not been assigned.

Go to QA02 - Change Inspection Lot and click on the Inspection specification tab, then click on Tasklist/Specifi and select the Inspection Plan

Save the lot.

Thanks and regards

Murugesan

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi

any error message has come after doing qa32?

reg

S.Anbalagan

Former Member
0 Kudos

Hi

1. If the start data was exceeded, the traffic light is red

2.If the end date was exceeded, the traffic light is red.

3. If the usage decision still has to be made. This means that if the end date has been reached and no UD has been made, the traffic light is red.

4. If there are outstanding short-term characteristics, the traffic light is red.

5. If there are outstanding quantities, the traffic light is red.

Regards,

Anand.

Former Member
0 Kudos

Dear Anand Sir,

You said all setting i read in F1.

But, confused to do necessary required setting.

please help me with t-code & settings.

Waiting

Former Member
0 Kudos

HI

As per my knowledge That red signal has no perticular adverse effect. As soon as the UD is made the signal light will be green.

Regards,

Anand.

Former Member
0 Kudos

Dear Sonal,

Is it that you are not able to do UD?

What is the status of the inspection lot? If not then release it first.

Revert with your problem exactly.

Sumeet

Former Member
0 Kudos

Dear Sir,

In first lot RED signal & at the end message CRTD

In second RED signal & at the end message REL

Why it is?

Which message we will required?

After UD, message is UD ACCEPT,but not showing anything.

How to do result recording.& transfer lot to unrestricted.

In Mat.Master I assigned 04 type.

Please reply

Former Member
0 Kudos

ok no problem u go to qa12 and give the ud is accepeted then there u select inspection stock tab

there u post the qty to unrestricted

Reg

S.Anbu

Former Member
0 Kudos

Dear Sir,

What is about results recording?

Where & when shud i do it?

Former Member
0 Kudos

Hi

r u doing incoming inspection in qa32 is it? then u must do in qa32 and if u want change then u can use qa12

for inprocess inspection u can do in qe51n

Reg

S.Anbu

Former Member
0 Kudos

hi

is it solved?

Reg

S.Anbu