on 04-01-2008 8:43 AM
Hi,
I am seeing 'Error in conversion exit CONVERSION_EXIT_CUNIT_INPUT for infoobject 0exect_unit when i tried to load a flat file. All the entries for 0exect_unit in my flat file is 'STD'.
How do i rectify this problem?
Thanks.
Cheers
Hi,
On top of infoobject 0exect_unit, i am also seeing the same problem with infoobject 0WM_UOT, where all entries are 'TAG'.
Please advise.
Cheers
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
check Table T006A (TCode se16) if that unit exists or not. if not first maintain there then load.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check out whether its an correct entry or not.I mean whether that is defined in the BI System or not.
Regards,
Shivu.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.