Skip to Content
avatar image
Former Member

Syntax error in program "CL_SALV_WD_C_TABLE============CP

I was working with a CR for a wda component and came up with the below issue in Dev client. The whole WDA component is syntactically correct but when I execute and go to the second view which has the ALV component(SALV_WD_TABLE), it shows """ERROR: Syntax error in program CL_SALV_WD_C_TABLE============CP .(termination: RABAX_STATE)""" in the browser but the same is working fine in Quality.

I reverted the changes that I did as well. Still the error persists. Kindly give me a solution ASAP. Thanks...


Error in the ABAP Application Program The current ABAP program "CL_SALV_WD_COMP_FACTORY=======CP" had to be terminated because it has come across a statement that unfortunately cannot be executed. In include "CL_SALV_WD_C_TABLE============CM03T ", in line 1 of program "CL_SALV_WD_C_TABLE============CP ", the following syntax errors have occurred: Class "CL_SALV_WD_C_TABLE" does not contain an interface "IF_SALV_WD_C OMP_TABLE_PERS". However, there is a similarly-named interface "IF_SAL V_WD_COMP_TABLE_IF".

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Dec 13, 2017 at 12:12 PM

    Have a look at OSS note 2540645

    Add comment
    10|10000 characters needed characters exceeded