Skip to Content
0

Cannot save data from Analysis for Office Input template

Dec 11, 2017 at 10:05 PM

467

avatar image

Hi Team,

We have an Advanced DSO over which Aggregation level is defined.

We have created a query over Aggregation level in HANA Studio to save data from Analysis for office template.For this we enabled the check box under Planning section in General Tab of the Query in HANA studio which is : Start Query in Input Mode.

Now in AO template, we are trying to enter some data but Save Data option in Analysis is disabled. We also checked the Components tab for the same query in AO workbook. There the option :Planning: Open Data Source Input Enabled is disabled.


Are we missing any option which will help to successfully save data using the AO input form.


Thanks,
SHUBHAM

10 |10000 characters needed characters left characters exceeded

Hi - is the Planning Ribbon active? Which version of Analysis Office are you using?

0

Hi Pammy,

Yes the ribbon is active.(Image attached)

Currently we are on 2.5 SP 2 patch 1 setup of AO

planning-ribbon.png

Regards,
SHUBHAM

0
* Please Login or Register to Answer, Follow or Comment.

2 Answers

shubham verma Dec 11, 2017 at 10:23 PM
0

Hi Pammy,

Yes the ribbon is active.(Image attached)

Currently we are on 2.5 SP 2 patch 1 setup of AO

planning-ribbon.png

Regards,
SHUBHAM


Share
10 |10000 characters needed characters left characters exceeded
Gregor Dieckmann
Dec 12, 2017 at 01:10 PM
0

Hi,

a lot of settings may lead to not input-ready cells, e.g. your query might not use the 'disaggregation' setting; in this case all cells aggregated with respect to the aggregation level are not input-ready. Also check the messages you might get when you open the query.

Regards,

Gregor

Remark:

The save button is only active after changing a cell value.

Share
10 |10000 characters needed characters left characters exceeded