Skip to Content

WSDL generated from ECC is not working through HCI

Dear Experts,

I've 2 wsdl's generated from 2 different ECC systems.

One is working fine. Second wsdl one is working fine with SOAP UI tool, however when I configure this second wsdl in HCI SOAP sender or receiver channel it is giving me error saying
"Invalid port and service". below is HCI screenshot:

System 1 wsdl looks like:

System 2 wsdl looks like this.

We have used the same procedure to generate both wsdl's. Let me know if you have any suggestions to come out of this problem.

Regards,

Vidhya

capture1.jpg (21.8 kB)
capture3.jpg (78.0 kB)
capture2.jpg (114.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Dec 22, 2017 at 02:04 PM

    Hi Vidhya,

    Your wsdl reffers to a local (LAN) resource. So it is obvious that SCI cannot reach this service, since it resides on a cloud system.

    You will need to install SAP Cloud Connector to enable this type of communication or expose the ERP's URL using a reverse proxy approach.

    I strongly recommend you to use Cloud Connector to do it. Follow the instructions on this blog to have a connector up and running.

    Regards,
    Ivan

    Add comment
    10|10000 characters needed characters exceeded