Skip to Content

How to increase the size of the classical report output : ME49

zme49-new.jpgzme49-new2.png

Dear All,

I have a requirement that I want to increase the font size of the classical report output .I have made a z copy of the report ME49 .

I am executing my classical report : ZME49_NEW and getting the output on screen and the fonts of the text printed on screen are fine .

But when I take the print of the report output .After printing the fonts are very small in size .

Can anybody suggest me some workaround or ideas to change the font size of the output which I am getting through printer on a4 sheet .

I have used the below line-size and line-count .

REPORT ZME49_ME49 NO STANDARD PAGE HEADING LINE-SIZE 1023

LINE-COUNT 1023 .

Please suggest some ideas for method to increase the fonts size .

Regards

Deep

zme49-new.jpg (89.1 kB)
zme49-new2.png (82.8 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Dec 11, 2017 at 09:27 PM

    If you read the documentation, you will understand quickly that LINE-COUNT is not related to your issue.

    If you defined LINE-SIZE 1023, it means that your report output is VERY wide, so it's normal that it prints with small characters so that the paper can contain all these 1023 characters (actually, it's limited to approximately 200 characters, otherwise the characters would be too small to be read).

    Your question is related to transaction SPAD: cf "format types", "device types" and "actions" for each given couple of format type/device type (hexadecimal code sent to the printer to define the font size).

    Add comment
    10|10000 characters needed characters exceeded