Skip to Content
avatar image
Former Member

BPM for merging

Dear All,

I have a BPM that merges files .

I have put 2 files on source side.

I am getting 2 lines in MONI . One line for file A to IP and second line for file B to IP.

Both of them are showing chequeured(success) flag as status but the outbound status is "message being sent".

I am not getting any line in MONI for IP to target.

Kindly help

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Mar 07, 2008 at 01:02 PM

    Sunil,

    Did u checked the IP, the two messaes reached BPM , first of all?

    raj.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 10, 2008 at 07:45 AM

    Hi

    What's the component as you use it in BPM?

    Is it fork? If it yes, You need to design correlation. The correlation with check the condition of those messages. Whenever the condition is true the message will process. You can find example and description about this from http://help.sap.com/

    Thanks

    Park

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 10, 2008 at 09:18 AM

    hi Sunil,

    today only i have done the same scenario.

    i have faced the same problem .

    It was due to incorrect source file.try to make source file using 2 different msg mapping with single files.

    i have tried it with both series & parallel(fork) conditions. In both case u have to use correlation. In fork u have to check both start process option but for series u have to check start process option for first recieve.

    hope it will help u.

    thanx & regards.

    Raj

    Add comment
    10|10000 characters needed characters exceeded