Skip to Content
avatar image
Former Member

How to manipulate BP number in BADI BUPA_INBOUND?

Hi experts,

Has anybody an idea if and how I can influence the BP number in BADI BUPA_INBOUND?

I use the BADI for the synchronization of HRM and BP in S/4 Hana. Unfortunately the customer requirement is to have a specific external number range for employees (numeric prefix + personnel number). To enable synchronization and automatic creation of BP from HR employee I need the BP number changed.

Any hints are welcome. Thank you.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Nov 28, 2017 at 02:05 AM

    Hi, not too sure about your scenario.

    How do you sync your employees with S/4?

    Do you have a stand-alone HCM system?

    How do you sync your employees with S/4 BP? Do you use messaging or the sync report /SHCM/RH_SYNC_BUPA_FROM_EMPL?

    Regards, Ingo Bruß

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 28, 2017 at 01:05 PM

    Hi,

    thanks for your feedback. I use /SHCM/RH_SYNC_BUPA_FROM_EMPL for creation/synch of HCM employee with BP in S/4 HANA. I have only one S/4 client with HCM data (more or less name of employee and email address) and BP.

    SLG1 repeats errors with number ranges that do not correspond.

    I want the BP (BUP003) to be created automatically (by daily synch run) after employee is created.

    best regards

    Jens

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 30, 2017 at 02:46 AM

    Hi,

    Using HRALX PNUMB and HRALX PSUBG switch : use these switches to provide/configure to have different number range to BP. refer T77S0 switch documentation for more info. 


    You can also refer, Simplification list note 2340095’s attachment where sync reports functionality s explained in detail.

    This functionality was not available in early version, check you are in appropriate SP if not you can implement the note 2361914

    Best regards, Suresh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Suresh,

      thanks for your Input. I've already checked these notes and functionality. But I still need to set the number because we created blueprint before notes were available and FPS was released.

      Do you know how to set BP number in the given method / BADI?

      thanks and best regards

      Jens