Skip to Content

Master data is seen in Infoobject, but not in Infocube

Hello Everyone,

I'm checking an infocube(FI-AR related custom infocube) which has clearing date in it. However, the clearing data used in the infocube is an attribute of a master data infoobject(Subledger ID - Clearing Date) which can be seen in the infoobject data, but when i/m displaying data in infocube I'm unable to view the date.

Any suggestions ?

Regards,

Krishna.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Nov 28, 2017 at 05:28 AM

    Hi

    First check the InfoObject is Navigational attribute or Display attribute.

    Could you please once again activate Info-object after loading master data and next activate info-cube , so that it will display the data.

    Thanks & Rgards

    Sreenivasulu Konka

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Sreenivasulu,

      Thanks for your feedback.

      The clearing date is a navigational attribute. Further, the infoobject is already active(as below) where the Financial document has been cleared on 18.10.2017 and it has been loaded in to master data through the "delta".

      Or should I load the master data once again ?

      Regards,

      Krishna.

      capture.png (5.9 kB)