Skip to Content
avatar image
Former Member

IDoc to R/3

I wanted to know that I have seen my idoc to go to R/3 system but that is not the one to which it should go

eg-client of this r/3 system is 600 but i want it to go to r/3 system of client 110

Also all the ALE settings have been done for the required R/3 system

But I want to know what change shud i make so that idoc goes to the r/3 110 client system

Also do i need to do all the sm59 and we21 settings again making a new Log system and RFC destination or else what changes shud i make to the existing one?

Also plz tell me the various types of idocs and where can i see the different layers of idoc(Control,status etc...)

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Feb 15, 2008 at 02:22 PM

    RFC Destinations are independent of Clinet. Mention the Client number in the IDoc receiver adapter.

    VJ

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 15, 2008 at 03:51 PM

    I think it is the business system(BS) that directs the IDOC to the client. If you have BS for client 110 and used in ID receiver then you will get IDOC there. Correct me if I am wrong

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 15, 2008 at 04:14 PM

    Hi,

    > i want it to go to r/3 system of client 110

    For the Client 110 you would have maintained seperate Busines System .

    > Also do i need to do all the sm59 and we21 settings again making a new Log system and RFC destination or else what changes shud i make to the existing one?

    Yes for the Client 110 Business System Creat RFC Destination..Port.. Similar to your Client 600 Business System

    Regards

    Agasthuri Doss

    Add comment
    10|10000 characters needed characters exceeded