Skip to Content
avatar image
Former Member

Wrong EDI_DC40.SNDPOR field in sender IDoc

Hi to all,

I have an IDoc to IDoc tunneling scenario. When the IDoc goes out from the sender system, it has a wrong port into the EDI_DC40.SNDPOR field. How can I change this? there is a SAP transaction that mantains this value?

Thanks to all!

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Feb 14, 2008 at 10:47 AM

    Hi,

    You can change the Output type from EDI to ALE while creating the IDOC.

    Regards

    Seshagiri

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 14, 2008 at 10:57 AM

    Hi,

    For IDOC tunnelling even if the sender port information in not appropriate

    You could do this with below alternatives

    for e.g.

    1. Switching Off ALE audit messages

    At times, there could be a scenario where in we do not need the ALEAUD IDOCs to be got back.To acheive this add the PORT,CLIENT and MESSAGETYPE to the table IDXNOALE.Use transaction SE16 -> specify the table name "IDXNOALE" and then choose create new entries.Specify the values for PORT, CLIENT and MESTYPE fields, save the entry.This procedure helps switch off ALEAUD IDOCs from being sent back to the sender SAP system.

    2. Refer the links

    /people/ravikumar.allampallam/blog/2005/02/23/configuration-steps-required-for-posting-idocsxi

    XI: IDOC to IDOC tunneling - how fast (and easy) can you get?

    /people/michal.krawczyk2/blog/2005/11/21/xi-idoc-to-idoc-tunneling--how-fast-and-easy-can-you-get

    3. In transaction We20 you could rectify the sender Port for the proper logical system.

    Thanks

    Swarup

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hello Gabriele,

      Just to make it clear the FM which you are talking about is always present in process code of inbound message type parameter of your receiving (PI system). That FM will contain within it another FM 'IDOC_MASTER_DISTRIBUTE', which will create the control, data and status record of your corresponding IDoc.

      For your case, in order to maintain the correct sender port number, you can have a look at t-code WE21 (since this is the case with sender ECC).

      Regards,

      Souvik